0E-COMSMOKE 4-Wire Conventional Photoelectric Smoke Detector
Photoelectric Smoke Detector

← back

4-Wire Conventional Photoelectric Smoke Detector

0E-COMSMOKE

Key features

Photoelectric Smoke Detector

• For Conventional 4 wire applications, compatible with any UL listed 4 Wire Fire Alarm Panel
• Wide-angle, dual red LEDs
• Low standby current
• Form A relay output
• Plug in detector line
• Mounting base included
• 12/24VDC

The 0E-COMSMOKE is 4-wire conventional photoelectric smoke detector with mounting base. This detector is designed to provide open area protection and to be used with compatible UL listed 4 Wire Fire Alarm Control panels only. Two LEDs on each detector provide local 360° visible alarm indication. LEDs flash every five seconds indicating that power is applied and the detector is working properly. The LEDs latch on in alarm. LEDs will be off when a trouble condition exists indicating that the detector sensitivity is outside the listed limit. The alarm can be reset only by a momentary power interruption. The plug in detector base is intended for use in 4-wire systems, with screw terminals provided for power and relay output connections.

Technical specifications

Diameter: 4.04 inches (102 mm) installed in detector base
Height: 2.11 inches (54 mm) installed in 0E-COMSMOKEB Base
Weight: 4.24 oz. (120 g) installed in detector base
Operating Temperature Range: 32~120°F (0~49°C)
Operating Humidity Range: 10%~93% Relative Humidity non-condensing
Operating voltage: 8.5~35VDC
Standby Current: 90μA average
Alarm Current: 36mA @ 24VDC
Alarm Contact Ratings: 0.5 Amp @ 30 V AC/DC
Latching Alarm: Reset by momentary power interruption
Alarm Reset Time: 0.3 sec

Product Certification: UL Listed S35851 fire alarm subassembly

Datasheet
0E-COMSMOKESpecsheet-onepage_finalv1-1508748305.pdfdownload
Full Manual

Your privacy is important to us. We published an updated Privacy Statement. Please read these updated terms.
We use cookies to create the most secure and effective website possible. By using this site, you consent to the use of cookies. Full details in our Privacy statement.

Click here to not show this message again.